I
nstAll
h
Ard
d
Isk
d
rIves
The instructions below apply to all types of drive carriers intended for use with the
Vess A3120 system.
1. Remove a disk drive carrier.
2.
Carefully lay the disk drive into the drive carrier at the front, so that the
screw holes on the sides line up.
3.
Insert the screws through the holes in the drive carrier and into the sides of
the disk drive.
See illustration on next page
.
Install only the counter-sink screws supplied with the drive.
•
Install four screws per drive.
•
Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive carrier into the enclosure.
5. Repeat steps 1 through 3 until all of your disk drives are installed.
Counter sink screws; two screws on each side.
Push in the center to insert the drive carrier into an empty drive bay.
Pull handle to release the
latch, then pull straight out
gripping the handle.
Place your free hand
underneath when removing or
inserting the carrier containing
a hard disk drive, so you do
not drop it.
Promise Technology
12
Quick Installation Guide
