121
Managing the Pegasus3
Pegasus3 Product Manual
Performing a Manual Rebuild
To perform a manual rebuild:
1. Click on the
Background Activities
icon.
2. Mouse-over Rebuild and click the
Start
button.
3. From the
Source Physical Drive
dropdown menu, choose a
Source
disk array and physical
drive.
Arrays have an ID No. Physical drives have a Seq. No.(sequence number)
4. From the
Target Physical Drive
dropdown menu, choose a
Target
physical drive.
5.
In the Confirmation box, type the word “confirm” in the field provided and click the
Confirm
button.
When the disk array is rebuilding:
•
The disk array shows a green check
icon and
Rebuilding
status.
•
Logical drives under the disk array continue to show a yellow
icon and
Critical,
Rebuilding
status.
• If the buzzer is enabled, the Pegasus unit emits two quick beeps every five seconds. When
the beeps stop, the rebuild is done.
Rebuilding a disk array
Summary of Contents for Pegasus3 R4
Page 4: ...iv Promise Technology Pegasus3 R4 R6 R8 VCCI KCC FCC ...
Page 5: ...v About this guide Pegasus3 Product Manual WARNING WARNING WARNING WARNING ...
Page 80: ...67 Managing the Pegasus3 Pegasus3 Product Manual Controller Settings ...
Page 207: ...194 Promise Technology Pegasus3 R4 R6 R8 View NVRAM Events ...