ProMinent OZLa 06 O, Operating Instructions Manual

Page: 59 / 72

Ozone generation sys‐
tems
Unit OZLa 06 O OZLa 08 O OZLa 12 O OZLa 16 O
Gas volume at an output
of 200 g/Nm
3
N 3 /h
Min. concentration vol% 90 90 90
Max. dewpoint °C -50 -50 -50
Pressure bar 3 ... 6 3 ... 6 3 ... 6
Max. particles µm 5 5 5
Max. hydrocarbons ppm 20 20 20
Temperature °C 5 ... 30 5 ... 30 5 ... 30
Cooling water
Cooling water require‐
ment (15 ℃)
l/h 2280 3040 4560 6080
Cooling water require‐
ment (30 ℃)
l/h
Cooling water inlet pres‐
sure***
bar 2 ... 5 2 ... 5 2 ... 5
Cooling water inlet Rp 1" 1" 1" 1"
Cooling water drain, free
flow
mm 12 x 9 12 x 9 12 x 9
Cooling water quality No tendency for calcium precipitation, no corrosive ingredients,
Sedimentation substances: < 0.1 ml; Iron: < 0.2 mg/l; Manganese: < 0.05 mg/l;
Conductivity: > 100 μS/cm;
Chloride: < 250 mg/l
*) Output of 150 g/Nm 3 must be factory configured as a non-standard design
**) Nm 3 = m 3 under standard conditions (p = 1.013 x 10 5 Pa, T = 273 K)
***) 2 bar only with free flow directly at the system
14.2 Power supply to the system
Tab. 4: Electrical inputs and outputs of OZLa01
Parameter Value
Mains frequency 50/60 Hz
Nominal voltage 230 V +/- 10%
Connection to L1, N, PE
Please refer to the terminal and wiring diagrams in the Appendix for all further information.
OZLa01
OZLa02-16
Technical data
59