USER’S MANUAL. TV EXPLORER II/II+
Page 30
12/2013
In
frequency tuning mode
there are two ways of tuning:
1.
Turning the rotary selector
[1].
Turning the rotary selector [1] selects the desired frequency (tuning is
continuous from 5 to 1000 MHz and from 950 to 2150 MHz). When turning it
clockwise frequency increases while turning it anticlockwise frequency
decreases.
2.
Using the keyboard
.
Press the rotary selector [1] (the frequency listing will disappear and will
appear on the upper left corner of screen the keyboard symbol of manual data
entry
), next enter the frequency value in MHz using the numeric
keyboard. The
TV EXPLORER II / II+
will calculate the tuneable frequency
closest to the entered value and then display it on-screen.
5.5
Automatic Transmission Search
Holding pressed the
[25] key search starts over the active channel plan. When
tuning a channel the instrument tryes to identify it and save it with the configuration. If
the identification is not possible the channel is removed from list. As a result obtains a
new channel plan that only contains the channels that have been identified.
5.6
Selecting the measurement configuration: Analogue/ Digital signal
Measuring the characteristics of a channel depends, in the first place, on the type
of modulation: analogue or digital.
Use key
[17] to switch between analogue and digital channels. Press the
[17] key to show the
measurements CONFIGURATION
menu and select the
Signal
option by turning and pressing the rotary selector [1]. The
Signal
option allows setting
the type of signal to measure. When switching to a new type, the
TV EXPLORER II / II+
activates the last measurement configuration used for that type of
signal.
