9
maximum capacity of the water tank is 1.8 liters.
Close the water tank by screwing the safety catch (7) downwards and turning it clockwise as far as it will turn.
Starting the Unit
Connect the electrical cord to the wall outlet.
Switch on the appliance by pressing the ON/OFF switch (2). The Red Operating Control Light will light up (See Image B2
above)
Connect the end of the steam gun (12) to the steam connection (6) until it engages with a audible clicking noise. (See Image
B3 above)
To remove the steam gun (12) press the 2 side snaps and pull it out. (See image B4 above)
The appliance is ready for use as soon as the green light for the steam status is lit.
Next attach the accessories as described in the section called “Accessories”.
The unit has a steam pressure lock to prevent it from being activated accidentally. Press the Steam Pressure Lock (15) and
the Steam Pressure Knob (14) will be locked. Pressing the Steam Pressure Lock (15) again to release the lock and the
steam and the Steam Pressure Knob can be used again (See Image B5 above).
Press the Steam Pressure Knob (14). The Steam Pressure Lock (15) must be released as you do so. Some drops of water
may be omitted. This is only water that has condensed in the pipes. In the case direct the steam towards a cloth rag and
hold the Steam Pressure Knob (14) until all the water is omitted.
To increase the volume of steam being omitted, turn the steam regulator (5) counter clockwise. To reduce the volume of
steam, turn the steam regulator (5) clockwise. (See image B6 above)
Accessories
Some of the accessories are housed on the steam cleaner in the accessory compartment. To open the casing and press the
release button (8) and lift the top of the steam cleaner unit off. This is also the same way if the user was going to use the
accessories with the unit as taking the unit off its base makes it mobile for tool use.
To extend the steam gun (12) for example the floor tool, you can use any three of the extension tubes (19). Do this by
attaching the extension tube (19) to the steam nozzle (13) until you hear an audible click. You can now attach the next
extension tube as needed. (See image B8). To remove the extension tubes press the knob to release it (16) and pull of the
tube (see image B9).
The accessory adapter (21) can be attached straight to the steam nozzle (13) or to the extension tube (19). Attach the
accessory adapter until it is engaged with an audible click. (see image B10)
The round brush (29) and 45 degree nozzle (30) can be attached to the accessory adapter (21).
The Compression nozzle (28) may be used by attaching it to the accessory adapter (21) and using the mark on the accessory
adapter (21) and turning it 90 degrees clockwise (see image B11). The following accessories can be used with the
Compression nozzle: Textile Brush (26), Glass Cleaning Attachment (27), Round Brush's (29) and 45 degree Nozzle (30).
The Attachment Connector (20) can be attached directly to the Steam Nozzle (13) or if needed to the Extension Tubes (19).
Attach the Attachment Connector (20) until it engages with an audible clicking noise. The following accessories can be
attached to the Attachment Connector: Attachment 17 with and without cleaning cloth (25).
When using attachment 17 hold the round end of the attachment connector (20) upwards so the hose connector points
