10
downwards. Place the round end of the attachment connector (20) in the opening in the attachment (17) until both parts
engage. Turn the attachment connector (20) through 180 degrees upwards (see image B12).
Use of the Accessories
Floor tool – Connect the Floor tool attachment (17) to the attachment connector (20). This attachment is used for cleaning
floors. It can be used with or without a cleaning cloth (25).
To attach the cleaning cloth to the floor tool:
Place the cleaning cloth on a flat surface.
Place the attachment (17) in the center of the cleaning cloth.
Attach the cleaning cloth to both sides of the attachment using the 2 clips (18). (see image B13) The cleaning cloth is
designed for cleaning sensitive surfaces like wood or parquet or for drying. To make sure your floors can handle being
cleaning with hot water contact the floor manufacturer and test a small part first.
45 degree Nozzle (30) & Round Brushes (29) -
Attach these tools (with pressure) to the Accessory Adapter (21) or the Compression Nozzle (28). These accessories are
designed to clean hard to reach places such as corners, edges etc. The round brush with yellow bristles is for places that
require abrasive cleaning (it is not designed for cleaning sensitive areas but areas like grills or tile grout etc). The round
brush with black brushes is designed for cleaning surfaces that are sensitive services. Use the round brushes with the brush
cloth (24) to dry surfaces after they have been cleaned.
Upholstery Brush (26) -
Using the mark on the brush attach the Upholstery tool to the Compression Nozzle (28) by using force. See image B14.
Glass Cleaning Attachment (27) -
Place the legs on the Upholstery Brush (26) into the the hooks on the Glass Cleaning Attachment (27) and press the
Upholstery Brush downwards until the 2 pieces connect together with an audible clicking sound. (See Image B15). To
remove the Glass Cleaning Attachment pull the legs forward and lift the Upholstery brush up. The Glass Cleaning
Attachment is designed to clean Windows, Mirrors, Glass Surfaces, and Ceramic tile.
Window Cleaning -
Step 1 – Spray steam evenly from a distance of 8 inches.
IMPORTANT – Glass can rupture or crack if water is to hot or glass surface is to cold. Before cleaning glass
always make sure glass surface is warm.
Step 2 – Switch off the steam and use the Squeegee Attachment to wipe off the moisture moving from top to bottom.
Filling the Water Tank During Operation-
1.
Switch the steamer appliance off by pressing the ON/OFF button.
2.
Make sure the Red operating control light (3) is no longer lit and unplug the electrical cord from the wall.
3.
Release the steam pressure by pressing the steam pressure knob (14).
4.
Slowly press the safety catch (7) downwards and turn it counter clockwise so that the remaining steam can escape
from the water tank.
5.
Make sure the water tank is empty. CAREFUL – any water in tank will be hot.
6.
Wait a few minutes and then top off the water level to a maximum of 1.9 quarts of water.
7.
Close the water tank by clicking the safety catch (7) downwards and turning it clockwise as far as it will go.
IMPORTANT – Any time you are working around hot water or steam always wear protective gloves.
