PROLIGHTS - EclNanoPanel
TWC
12
DMX ADDRESSING
In order to start controlling the product via DMX, the first step is to select a DMX address, also known
as the start channel, this is the first channel used to receive instructions from a DMX controller. If you
wish to control the product individually, it is necessary to assign a different starting address channel to
each fixture.
The number of channels occupied from the product depends on the DMX mode selected, so always
verify the DMX Mode in the MENU before start addressing.
If you assign two fixtures the same address, they will be executing the same behaviour. Selecting the
same address to multiple fixtures can be useful for diagnostic purposes and symmetrical control.
DMX addressing is limited to make it impossible to set the DMX address so high that you are left with-
out enough control channels for the product.
To set the fixture’s DMX address:
1.
Press MENU to open the main menu.
2.
Reach the addressing menu, then select the DMX ADDRESS settings.
3.
Select the address from 1 to 512 using the navigation arrows/buttons and confirm by pressing
ENTER.
4.
Press Menu to exit and return to the Home screen.
The product DMX address, as well as other possible user settings through the MENU, can also be
set when the product is disconnected from the Main through the internal battery-backup. All that is
needed is to press and hold the button ENTER to momentarily enable the display and enter in the
settings. Once the required operations have been executed, the display will switch off again after few
seconds of being inactive.
OPERATION AS A WIRELESS TRANSMITTER
ECLNANOPANELTWC can be used as wireless trasmitter for transmitt at different wireless receivers
DMX signal. To use ECLNANOPANELTWC as wireless transmitter, please follow the procedure below:
1.
Push MENU button untill you show CONNECT on display, then press ENTER button to confirm.
2.
Use UP/DOWN buttons for select Wireless, then press ENTER to confirm.
3.
Push ENTER button on WDMX ON/OFF function and enable it to ON.
4.
Select WDMX mode and set it on Transmitter (please note that WDMX mode will be available only
if WDMX ON/OFF is set to ON).
5. Ensure that the receiver units are not connected to any other transmitter. Please refer to "Reset the
receiver" paragraph.
6. Enable TX LINK to ON to link transmitter to receivers (please note that TX LINK will be avaible only
if WDMX mode is set to Transmitter).
CONSTRUCTION OF THE DMX TERMINATION
The termination is prepared by soldering a 120Ω 1/4 W resistor between pins 2 and 3 of the male XLR
connector, as shown in figure.
Fig. 06
Example:
5 pin XLR connector
4
