ERROR SHOWED ON
SCREEN
POSSIBLE CAUSES
COLOUR
MESSAGES
PCB
[DISPLAY BATTERY ERROR]
Battery not present or not detected from the display PCB.
Green
1U
[DMX ACTIVE]
If transfer configuration is used with dmx signal con-
nected.
Green
1U
[MAINTENANCE TIME]
Need to be done standard maintenance and also reset
of elapsed time.
Green
1U
[IGNITOR FAN ERROR]
Blower for Ignitor failed.
Green
1U
[POWER SUPPLY FAN ERROR] Blower for PSU failed.
Green
1U
[PAN/TILT PCB ERROR]
Pan tilt pcb not detected.
Blue
2U
[PAN MOTOR ERROR]
This message will appear after the reset of the product if:
•
the PAN magnetic-indexing circuit detect a failure
(sensor failed or magnet is missing);
• or the stepping motor is defective;
•
or its driving IC on the PCB is defective;
• or the product is not located in the default position
after the reset of the fixture.
Blue
2U
[TILT MOTOR ERROR]
This message will appear after the reset of the product if:
•
the TILT magnetic-indexing circuit detect a failure
(sensor failed or magnet is missing);
• or the stepping motor is defective;
•
or its driving IC on the PCB is defective;
• or the product is not located in the default position
after the reset of the fixture.
Blue
2U
[PAN SENSOR ERROR]
Pan sensor not detected.
Blue
2U
[TILT SENSOR ERROR]
Tilt sensor not detected.
Blue
2U
[PAN ENCODER ERROR]
Pan encoder not detected.
Blue
2U
[TILT ENCODER ERROR]
Tilt encoder not detected.
Blue
2U
[MOTOR PCB 2 ERROR]
Motor pcb 3U not detected
Blue
2U
[ROTATING GOBO WHEEL
ERROR]
Failure detected during the reset of the rotating gobo
wheel, if this wheel is not located in the default position
Yellow
3U
[GOBO FAN ERROR]
Blower for cooling the GOBO wheel failed
Yellow
3U
[ANIMATION WHEEL
ERROR]
Failure detected during the reset of the animation
wheel, if this wheel is not located in the default position
Yellow
3U
[ANIMATION WHEEL ROT.
ERROR]
Failure detected during the reset of the rotation of
the animation wheel, if this wheel is not located in the
default position
Yellow
3U
[CMY FAN ERROR]
Blower for cooling the CMY module failed
Yellow
3U
[MAGENTA ERROR]
Failure detected during the reset of the Magenta flag,
if the Magenta flag of the CMY module is not located
in its default position
Yellow
3U
[YELLOW ERROR]
Failure detected during the reset of the Yellow flag, if
the Yellow flag of the CMY module is not located in its
default position
Yellow
3U
18 - ERROR MESSAGES
The error is shown on the unit display. In the table below, the "ERROR SHOWED ON SCREEN" column
lists the possible errors, accompanied by a possible cause ("POSSIBLE" CAUSES "column).
The color of the error messages (listed in the "COLOR MESSAGES" column) is different for each board
it refers to ("PCB" column).
On page 32 you can see the location of the various pcb boards.
PROLIGHTS - Astra
Hybrid420
32
