Mototronik 24
12.3 Switching on/off the display
Make sure the battery is properly inserted and switched on, see chapter 10.
To switch the display on, press the on/off button once.
To switch the display off, press and keep pressed the on/off button for at least 3 seconds.
The display also switches itself off after approximately 5 minutes of inactivity. The display also switches off when you switch the
battery off.
If the (
!
) symbol appears on the display, it means that, while switching it on, the accelerator button was pressed. This is
a safety system that prevents the device from activating the motor accidentally while switching the system on.
With this symbol on the display, the device does not work. To unlock the device, switch the display off and then switch it
on without pressing the accelerator button.
12.4 Speed selection
When you press the
+
button, you increase the speed level; with the
▬
button, you decrease it
.
The display will highlight the speed level (1, 2, 3, 4, 5).
The speed levels are proportional to the maximum speed of level 5.
For instance, if the maximum speed of level 5 is 15 km/h, level 1 will allow for a speed of 3 km/h, 2 will allow 6 km/h, 3 will allow 9 km/h, and 4 will allow 12
km/h.
The maximum speed of level 5 is adjustable, see chapter 13.
12.5 Forward/reverse gear
When the switch is in the central position or on the left-hand side, the driving direction is forward.
When you move the switch to the right-hand side, you engage the reverse gear.
When you engage the reverse gear and throughout the time of use, the system beeps intermittently and the display will indicate the blinking red letter
R.
As a safety measure, after engaging the reverse gear, the motor does not receive the accelerator control and, therefore, it does not spin the drive wheel.
This is particularly useful if, for example, behind the user, there is a flight of stairs that could be taken unintentionally due to an accidental or otherwise
unwanted engagement of the reverse gear.
To start driving in reverse gear, it is always necessary to press the accelerator button all the way down, then release it, and finally press it to move at speed within the set limits that are very small
compared to the forward gear.
The maximum reverse gear speed is adjustable, see chapter 13.
