Air
R
emo
te TTL
-C
15
www.profoto.com
The figure shows the Display [2] when:
•
MAN mode, 1st-curtain sync, and channel 1 are selected.
•
Group C is selected to be adjusted.
•
Lights/Heads in Group B are turned off.
•
The modeling light is turned on in both group A and C. If the light
output for group A or C is adjusted, the energy change will be
shown momentarily.
NOTE:
• Press the ENERGY button to increase/decrease in 1/10 f-stop increments.
• Press and hold down the ENERGY button to increase/decrease in 1 f-stop increments.
• If a light output cannot be set by the flash because it is outside its energy range, the Air Remote TTL-C beeps
to signal that the command was not executed. The light output of all flashes in the selected group then remains
unchanged.
• When all groups are selected the remote will also control lights in group D,E or F (selected on flash).
Test sync
•
Press the Test button [6] to manually transmit a sync signal.
