PROFILO Supurix PBT1260B, User Manual

Page: 10 / 14

14
PBT1260B-001_v01
Trouble Shooting
Some problems may be easily removed on your own. Before you contact the service centre, see the table below for a possible
solution to your problem with the unit. If the problem persists, contact the info line or your local service centre.
PROBLEM POSSIBLE REASON SOLUTION
The appliance will not turn on. The appliance is not correctly plugged
in to the outlet or is not turned on.
Insert the plug of the appliance into
an appropriate outlet (see the rating
plate on the appliance) and turn on the
appliance.
The outlet is damaged. Plug the appliance into other outlet.
The appliance will not emit steam
(or steam emission is reduced) when
working with the steam function.
The water tank is empty. Fill the water tank.
The indicator light HEAT illuminates but
the HEAT switch is not put correctly in
the ON position.
Make sure that the HEAT switch is in
the ON position.
The roller of the electrobrush will not
roll.
Large obstacles have blocked the
nozzle.
Remove the obstacles from the nozzle.
Hair, threads or large obstacles had
been accumulated in the roller and
blocked its operation.
Turn off the appliance and unplug
it from the outlet. Then remove the
obstacles blocking the roller (see
the ELECTROBRUSH CLEANING
section).
The appliance still will not operate
correctly.
Contact the service centre.
3 Replace the used filter with a new one. Press the new
filter so that it touches the unit base closely.
4 Refit the water tank.
CLEANING THE ELECTROBRUSH
Over time pieces of threads, strings, hair,
fabrics, etc accumulate on the roller of the
electrobrush. They impact the sweeping
performance and therefore the roller should be
periodically cleaned (at least once monthly).
Before cleaning the electrobrush, unplug the
unit from the outlet.
The roller of the electrobrush may be removed for thorough
cleaning.
1 Turn the roller lock located at the bottom of the cleaning
head to the position.
2 Remove the roller lock and the roller from the unit.
G
3 Using scissors or a sharp knife, carefully clean the roller
of the electrobrush. Using scissors or a sharp knife, cut hair
or threads rolled around the roller.
Be careful no to damage the bristle and the
roller of the electrobrush.
4 When cleaned, refit the roller.
5
Refit the roller lock and turn it to the position. The
roller is now locked.
DISASSEMBLING THE HOLDER AND
STORING THE UNIT
The holder is detachable for easy storage of the unit in low
cabinets.
1 Twist the upper cord wrap downwards.
2
Unwind the cord from the wraps.
3 Press the tube lock and slide out the tube with the holder
upwards.
E