9-21
Time Protocols
TimeP: Viewing, Selecting, and Configuring
Enabling TimeP in DHCP Mode.
Because the switch provides a TimeP
polling interval (default: 720 minutes), you need only these two commands for
a minimal TimeP DHCP configuration:
For example, suppose:
■
Time synchronization is configured for SNTP.
■
You want to:
1. View the current time synchronization.
2. Select TimeP as the time synchronization mode.
3. Enable TimeP for DHCP mode.
4. View the TimeP configuration.
The commands and output would appear as follows:
Figure 9-16. Example of Enabling TimeP Operation in DHCP Mode
Syntax:
timesync timep
Selects TimeP as the time synchronization method.
Syntax:
ip timep dhcp
Configures DHCP as the TimeP mode.
show timep
displays the TimeP configuration and also shows
that SNTP is the currently active time synchronization mode.
1
2
3
4
show timep
again displays the TimeP configuration and shows that TimeP is
now the currently active time synchronization mode.
3500-5400-6200-8200-MCG-Jan08-K_13_01.book Page 21 Monday, January 28, 2008 10:04 AM