DLC16 / T-DLC16
Digital
Temperature Switch
M-33-02
T-DLC16 Manual
Revision
– Date: 03 – 03/30/2016
1
Dimensions
Specifications
Probe Range:
-58°F to 302°F (-50°C to 150°C)
Input:
1.5-
inch (4 cm) thermistor (1000Ω @
25°C) with 10-foot (3-meter) cable
Accuracy:
±1°
Resolution:
±1 digit
Output:
16 amp SPDT relay @ 250 VAC
Horsepower Rating:
3/4 HP
Supply Voltage:
120VAC or 240VAC
Supply Power:
4 VA (230V)
Ambient Temp:
14°F to 158°F (-10°C to 70°C)
Storage Temperature:
-4°F to 176°F (-20°C to 80°C)
Front Panel Protection:
IP64
Display:
RED, 3-Digit LED
The DLC Digital Temperature Switch is a compact, easy to
program temperature controller.
3-digit LED screen displays probe temperature
error or alarm messaging
available in 120VAC or 240VAC
non-volatile memory storage
includes a thermistor with 10ft cable and fitting clips for
panel mounting
Note:
Mount DLC away from vibration, impacts, water and
corrosive gases.
1.
Locate appropriate installation site.
2.
Cut hole in panel 2.80 x 1.14 inches (71 x 29 mm).
3.
Apply silicone (or rubber gasket) around the perimeter of
the hole to prevent leakage.
4.
Insert the T-DLC into hole in the panel.
5.
Slide removable fitting clips onto the T-DLC from the
back to secure to panel.
6.
Remove the back cover to wire the T-DLC (see Figure 2,
T-DLC wiring).
7.
Replace cover once wiring is completed.
Note:
Probe cable length must not exceed 328 ft (100 m).
Do not install probe cable near power cables.
Installation
Figure 2:
DLC Wiring
Wiring Diagram
up
def
out
down
set
T - DLC16
– 1 - C
Figure 1:
Model Number Description
Thermostat
Only
Series DLC
Amperes
(16 Amps)
Voltage
1 = 120VAC
2 = 240VAC
Celcius Display
(Optional)
