Page 55
13.6.11 Options
Select “Setup” and “Options” from the menu.
Installed options can be activated and
deactivated for each user profile. Only
installed options are shown.
13.6.12 Reset settings to factory default
Select “Setup” from the menu.
“Reset settings to factory default” will reset all
settings of the Zehntner ZRM 6010 to factory
defaults. This cannot be undone. If you are
sure to carry out the reset to the factory
default you need to confirm this message.
13.7 Diagnostics
Select “Setup” and “Diagnostics” from the menu to display diagnostic information.
The following information will be displayed:
•
Device name
•
Company name
•
Device serial number
•
Software version
•
Measurement counter
•
Disk space
•
Last calibration R
L
•
Next factory calibration
•
Cal Code
•
Device version
14 Built-in battery and charging
14.1 Battery
The LI-Ion-Mn battery used has a very high capacity. The capacity is continuously
being observed. When the voltage becomes too weak the battery sign is shown
on the display and the battery has to be charged.
