Seite 32
7.3.3 View and edit all layouts
To show all existing layouts
, select „All layouts“ in the menu. A list of all saved
layouts will be displayed. The active layout will be shown as “selected”.
To change the name or settings of a layout, tap the relevant entry in the list. The
values can then be changed in the same way as described in chapter 7.3.2 on page
31.
7.4 Motor settings
Various settings for the drive motor can be changed via „Settings“ -> „Motor
settings“ in the menu.
7.4.1 Return speed
Return speed sets the speed at which the holding device (8) returns automatically
to the zero position after application when in „Reverse“
mode.
7.4.2 Manual speed
Manual drive speed sets the speed at which the drawing unit (23) moves when
using the „manual back“
or
“manual forward”
buttons.
7.4.3 Speed mode
There are two speed modes:
Normal 0
– 300 mm/s:
The normal speed mode is appropriate for most uses.
Fast 0
– 600 mm/s:
The fast mode is for applications requiring high
drawing speed.
If not specifically required otherwise, i
t is recommended to use the „Normal“ speed
mode for most applications.
