Seite 21
6.2 Application with wire-bar or profile rod
•
Place the device on a solid, even surface.
•
Level the apparatus using the included spirit level. To do so, place the spirit
level on the plate and adjust the levelling feet (9) until the Proceq ZAA 2600 is
levelled perfectly. The glass plate must be firmly in place.
•
Make sure that the printing blanket side of the glass plate is facing up.
•
Ensure that the printing blanket is covered with the polyester mat.
•
Set the „Moving Mode” to „Single“, by tapping on „Menu“ and „Setup“ on the
touchscreen. The „Single“ mode is indicated with a straight arrow
on the
main screen.
•
Lift up the weight (7) and hinge it into the top position (6).
Set the start stop (1) as follows:
•
Move the open clamping device (5) and the holding device (8) to the back of
the apparatus.
•
Place your substrate (e.g. test chart / film) at the desired position on the glass
plate and fix it with the clamping device (5), by pulling on the clamping grip (3).
•
Move the holding device (8) to the start stop (1) or to the desired starting
position using the
button on the touchscreen.
•
Press the
„Zero“ button
on the touchscreen to set the start position.
Hint: Small substrates can also be fixed with a piece of adhesive tape.
If the device had been shut down, the starting position has to be set again
after the next switch-on.
