probst SH-2500-UNI-GL, Operating Instructions Manual

Page: 118 / 145

Operation
40 / 58
52400046 / 52400048
5. Press both buttons (12.1) on the operating panel or
radio remote control (optional) at the same time.
6. Raise the lifting device again without the load.
7.10 Parking the Lifting Device
NOTE
Damage to suction plates due to inappropriate storage position!
 Do not set the lifting device down on the suction plates.
1. Switch off the vacuum generator.
2. Disconnect the power supply.
Options for correct parking:
7.10.1 Leaving the lifting device hanging
1. Hang the lifting device from the lifting aid in a safe position close to the ground.
2. If the lifting device cannot be parked close to the ground, then block off the danger zone underneath it.
3. Ensure that the lifting device cannot be used by unauthorized persons.
7.10.2 Setting the lifting device down without the suction plate
1. Remove the suction plate (> See ch. Changing the suction plate, Page 33).
2. Set the lifting device down on a level surface.
3. Secure the lifting device so that it cannot tip over.
7.10.3 Charging the battery