7
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
6
Visit
www.probrite.com/install
for installation video tutorials and product support
Installation (continued)
3
Remove the
mounting plate
C
DD
D
NOTE:
The mounting plate (D) comes pre-as-
sembled on the light fixture (A) for shipping.
NOTE:
The mounting plate tightening bolt (C)
comes pre-installed on the light fixture.
☐
Remove the mounting plate (D) from
the back of the fixture by loosening
the mounting plate tightening bolt (C)
using the allen key (DD).
4
Installing the
mounting plate
AA
D
Installation (continued)
5
Hang fixture to
mounting plate
6
Making the electrical
connections
TIP:
Ensure the light fixture (A) can safely
hang onto the mounting plate (D) to allow for
use of two hands to make the wiring (fig 2).
connections.
A
A
D
E
B
B
E
D
A
E
D
BB
(fig 1).
(fig 2).
TIP:
Only unscrew the tightening bolt (C) far
enough to remove the mounting plate (D). Do
not fully remove the tightening bolt (C).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
☐
Route the junction box wires through
the large center hole in the mounting
plate (D).
☐
Align the holes on the mounting
bracket (D) with the holes on your
junction box. Use two #8 screws (AA),
depending on the size of the holes in
your junction box, attach the mounting
bracket (D) to your junction box
☐
Please make sure
, the "TOP" arrow is
pointing upwards.
☐
Place the small sphere head of the
hanger wire (E) between the back of
the small grove located on the bottom
of the center hole of the mounting
plate (D).
☐
Ensure the photocell (B) is facing
upwards when light fixture (A) is
installed.
☐
If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐
Connect
fixture black wire to house
black wire
, the (+) line, and
fixture
white wire to house white wire
, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
☐
Connect
house ground wire to the
green fixture ground wire
, which is
attached to the mounting plate (D), by
twisting the exposed wires together
and using the wire nuts (BB).
TIP:
Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
