11
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
10
Visit
www.probrite.com/install
for installation video tutorials and product support
Operation
☐
Once the fixture is installed, turn power
back on from the circuit breaker and
switch.
☐
Flip switch ON and OFF to ensure light
functions properly.
Switch-controlled operation enables the light fixture to turn ON and OFF by
flipping a standard light switch.
OPTION 2: SWITCH-CONTROLLED
NOTE:
This fixture is not dimmable, so it
is best to not wire to a dimming switch.
1
Selecting Dusk-to-Dawn or
Switch-Activated control
OPTION 1: DUSK-TO-DAWN OPERATION
Dusk-to-dawn operation enables the light fixture to automatically turn
ON when dark outside and turn OFF when the sun rises, thus saving you
energy.
AUTOMATIC
NIGHTTIME ON
DAYTIME OFF
☐
To enable dusk-to-dawn operation
remove black cap cover (H) and ensure
the photocell has clear cap cover (DD)
on it and is unobstructed.
☐
Ensure the switch powering the outlet
connected to the light fixture is turned
to the ON position and
leave it ON
at all times to enable dusk-to-dawn
functionality to operate automatically.
NOTE:
If photocell (B) is located in an area
under heavy shade the photocell may not
detect enough light and may turn the light
fixture on. Either move fixture to less shaded
area or operate as normal switch-controlled
TIP:
To test if the light fixture (A) and
photocell (B) works properly run power to
the fixture and cover the photocell to turn
fixture ON. Shine a light into the photocell to
see if fixture turns OFF.
A
H
DD
Remove Opaque Cap Cover (DD )and
replace with Clear Cap Cover (H) on
photocell for Dusk-to-Dawn Operation
Swap
SWITCH
CONTROLLED
Troubleshooting
Problem
Possible Cause
Solution
Light does not
turn ON
No power to the fixture
Check if circuit breaker is tripped
Confirm wall switch is ON
Verify wiring to fixture is correct
(turn power off to fixture
beforehand)
Fixture is sensing daylight
Cover photocell. Wait several
seconds until fixture turns ON.
Light cycles
ON and OFF
continuously
Photocell light sensor is sens-
ing reflected light
Relocate light fixture to a location
where there is no reflected light.
OR place the optional photocell
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light
FLICKERS
The light fixture is wired
through a dimmer switch.
Do not use a dimmer switch to
control the light fixture. Replace
the dimmer with a standard
ON/OFF wall switch.
Light stays ON
Light sensor is in a shaded
area
Shine a flashlight into the light
sensor and wait a couple minutes.
If the light turns OFF, the fixture
should be moved to a location
with enough light in the daylight
hours for the light sensor to work.
OR place the optional opaque
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light Sensor is faulty
If the light does not turn off when
a flashlight is shined on the light
sensor for a few minutes, then
the sensor may be faulty. Please
contact customer service.
NOTE:
Photocell may have a few minute delay, to reduce it's sensitivity
to sudden light changes. When testing shine a light/cover the
photocell for a few minutes to check if fixture functions properly
