7
Locate the front of the main sail and find the rigging line
marked "H." Remove the label from the rigging line and insert
it into the inner eyelet of the gooseneck ("H"). The main sail
boom should be already attached to the outer hole of this
gooseneck. Leave approximately
1
/
2
" to 1" of space between
the bottom of the sail and the boom and secure around the
black cleat below the letter "H."
Locate the rigging line from the main sail boom that is
labeled "I."
Clip the rigging line to the lower gooseneck as shown.
Adjust the tension with the jib stay as shown.
Using the ruler on page 15, begin at the top of the main sail
and measure 3" down. Mark that spot on the sail between the
seam on the right and the left edge. Make four more marks that
are exactly 7" apart down from the initial mark.
Secure the luft rings on the
sail as shown.
Use a hobby knife, sharp
tweezers, or small drill bit to
carefully make the holes where
you have just marked the sail.
Section 2—Completing the Boat (continued)
26
27
28
29
30
31
Cleat
3''
7''
7''
7''
7''
