Blackjack 24
1.
Loosen the 2 screws on the rear of the canopy.
2.
Carefully lift the rear of the canopy and pull back to
disengage the 2 front pins from the hull.
3.
Install the battery in the compartment. Secure it with
the hook and loop straps. If running your boat in
rougher water conditions, the use of Waterproof Hook
and Loop Tape (DYNK0300) may also be needed to
fully secure the battery.
4.
Connect the battery pack to the ESC power
connector.
Antenna Tube Installation
Install the receiver antenna in the tube as shown.
Keep the end of the antenna above the boat’s
waterline to get the best transmitter reception.
Apply clear tape (DYNM0102), if desired.
NOTICE:
Do not cut or kink the
receiver antenna or damage may
result.
Installing the Battery Pack
Tip:
Move the packs forward or back to
adjust the center of gravity for your boat.
Move the packs toward the bow so the
bow rides lower in the water. Move the
packs away from the bow so that the bow
rides higher in the water.
6
EN
