PROALL G Series, Operator'S Manual

Page: 35 / 59

MX05001
6-3
Rev.
1
3 March 2022
Figure 6. Auger ball valve safety on/off (found by the
conveyor drive motor).
Drop-Away Bottom Mat
The gunite auger offers a drop-away bottom mat
to facilitate cleaning. Simply unhook the four
latches to have full access to its screw.
Remove three of the latches, leaving the middle
one, clean up ends then unhook the middle.
Figure 7. Drop-Away mat detail
Auger Bearing
IMPORTANT: The mix auger seal must be greased
regularly for lubrication and to keep contaminants
from wearing on the bearing and shaft
components.
Refer to Lubrication and
Maintenance Frequency on page 7-9 for
lubrication maintenance.
The lower bearing supports the auger shaft and
includes seals that help to keep materials from
exiting the mix auger.
Figure 8. Mix auger bearing and seals.
Mix Bowl
The mixing auger attaches to the mix bowl by way
of two removable mounts that enable the mix
auger to pivot up and down on the mix bowl. A
rubber shroud surrounds the interface between
the mix bowl and the auger in order to keep
materials from leaking out of the auger. The
shroud may be unhooked from the cover for
cleaning.