Usage instructions Adapter & Adaptation
29
10 Appendix: Front adapter settings
The following instructions are intended for and may only be carried out by a rehabilitation spe-
cialist dealer or PRO ACTIV.
Mounting the clamp cover in the clamping plate holder
The clamping plate holder offers three positions for the clamp cover: low, middle and high. To change
the position of the clamp cover in the clamping plate holder, unscrew the two M8 fixing screws from
the clamping sleeve (Metric size 6 mm), coloured blue in the figure. After repositioning the clamp
cover, the two fixing screws must be tightened again at 17 Nm and secured with screw locking fluid.
Angle adjustment and holder drill hole for the clamp cover
To change the angle adjustment of the clamp cover (7.5° up or down) or the position of the holder drill
hole for the clamp cover (high or low), the clamps on the steering head connection must be removed
on both sides of the adapter. To achieve this four M6 tensioning screws on each side (Metric size
5 mm) must be loosened, coloured green in the figure. By then screwing in each of the two M4
threaded pins (Metric size 2 mm), coloured red, the clamp is opened and the clamps on the steering
head connection can be moved to the side from the adapter.
M4 threaded pins
Middle mounting
High mounting
Low mounting
