Usage instructions Adapter & Adaptation
26
Figure 87: Docking plate terms
9.2
Adaptation on the product
For adaptation, the pre-selection level click
mechanism on the adapter head must be set to
"lock" (flat) and the eccentric clamp lever to
"loose" (upper neutral setting for grid). The
securing bolt is not inserted or if there is a
securing bolt with a nut this is pulled out to the
fullest extent.
Figure 88: Adapter settings at the start of adaptation
In the next step you apply the parking brakes
to your wheelchair. If you do not have the op-
tion to apply the parking brake, e.g. by using a
wheelbase extension, move your wheelchair
backwards against a wall.
For adaptation the insertion bolt of the docking
plate must be inserted into the insertion shaft
on the adapter head. You can pull the product
towards you via the wheels on the parking
stand.
Figure 89: Inserting the insertion bolt of the docking
plate in the insertion shaft on the adapter head
Figure 90: Insertion bolt inserted into the insertion
shaft on the steering head
Then switch the product on (see Usage in-
structions “wheel-e traction device”).
Insert reverse gear (see Usage instructions
“wheel-e traction device”) and ensure that the
handlebars are straight in the direction of
travel.
The coupling process is started by then gently
pressing the driving signal transmitter. By mov-
ing backwards, the adapter head approaches
the docking plate completely and the wheel-
chair moves upwards. This process is only
completed when the grid mechanism has
clicked into place with an audible locking noise.
Insertion bolt
Securing bolt
Eccentric clamp lever to "loose"
Pre-selection grid mechanism to "lock"
Direction
of travel
