Usage instructions Adapter & Adaptation
21
Figure 68: Adapter is adapted and ready for opera-
tion
Figure 69: Securing bolt with locking sphere, locking
sphere locked on the right outer side of the docking
plate
Before moving off, the parking stand must now
be moved from the active to the passive posi-
tion (on this refer to the "Stand" chapter in your
product usage instructions).
Additional information for the front adapter:
With the front adapter, it is an advantage to
couple the adapter onto the product using the
coupling fittings first before adapting the
adapter to the wheelchair. For this purpose,
the insertion shaft of the front adapter is cou-
pled to the insertion bolt of the docking plate.
Then the carabiner hooks of the coupling fit-
tings is coupled to the lifting eye of the bottom
bracket support. Now the front adapter is at the
optimum height for adaptation on the wheel-
chair.
Figure 70: Coupling fittings on the front adapter,
carabiner hooks in the lifting eyes
Figure 71: Setting the front adapter at the beginning
if the adaptation (pre-selection level click mecha-
nism and eccentric clamp lever)
Figure 72: Setting the front adapter at the beginning
of the adaptation
After the front adapter has been adapted to the
wheelchair, proceed as previously described in
order to connect the front adapter tight to the
product.
Securing bolt inserted
Coupling
fittings
Securing pin pulled
to the outer stop
Insertion shaft
of the adapter
on the insertion
bolt of the dock-
ing plate
Locking sphere
Carabiner
hooks in the
lifting eyes
Pre-selection grid
mechanism to "lock"
Eccentric clamp
lever to "loose"
