pro user DRC4311, Manual

Page: 6 / 49

6
11. After determining which wire is the positive and which is the negative, turn off the
12. Splice the red wire using the supplied in-
positive (+) wire. Use a set of slip joint pliers to squeeze the TAP and insure good
connection.
13. Next splice the black wire of the camera
-)
wire or ground.
14. Replace the reverse light bulb, and then re-install the light socket. Secure all the
wires with cable ties or electrical tape.
15. Re-attach the negative battery cable to the battery.
Monitor Installation
When choosing a location to mount the monitor, make sure the
monitor is in an area that will not obstruct your vision while driving.
1. Before mounting the monitor, clean the mounting surface well.
2. Position the suction mount to the smooth surface which suits
your requirement.
3. Press the suction cap against the smooth surface and press the lock down to attach
and fix the mount to the surface.
4. Snap in the monitor to the suction mount.
5. Adjust the mounting arms to suit your view angle to the monitor and tighten the
screws on the mount to fix the position.