Pro-face PS-3700A, User Manual, Page: 34 / 131

Chapter 2 Hardware Installation
2-7
2.1.6 USB Cable Clamp Installation
This holder prevents the USB cable from becoming disconnected due to vibration, etc.
(1) Place the PS-A unit face-down on a flat surface as shown below. Your PS-A unit has two USB connec-
tors.
[Attachment]
As shown below, insert the USB Cable Clamp’s band through the Bridge. Pass the USB cables through the
Cable Clamp’s band and securely tighten the clamp band around the cables.
[Removal]
To remove the clamp from the USB cables, push down on the clamp strap’s clip to release it while pulling up
on the clamp.
• When using only one of the USB ports, be sure to use the lower USB connector. This allows you
to securely clamp the USB cable in the cable clamp.
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing upwards - not to the
side. This is to keep the clamp from interfering with nearby connectors and their cables.
Upper USB Connector
Lower USB Connector
Clamp
Bridge
USB Cables
Cable Collars
Clamp
Strap Clip