Chapter 5 - System Setup
5-5
PL-5910 Series User Manual
Selecting either [IDE Primary Master] or [IDE Primary Slave] will call up the following
menu. The following example uses the [IDE Primary Master] setting.
IDE HDD Auto-Detection
This setting detects the hard disk connected to the IDE interface.
IDE Primary Master (Slave)
This setting designates the IDE type Hard Disk's parameter setting method.
The available settings are [None], [Auto], or [Manual]. The factory default setting is
[Auto] and is recommended for most users.
Access Mode
This setting designates the IDE type Hard Disk's access mode. The available settings
are [CHS], [LBA], [Large], or [Auto]. The factory default setting is [Auto] and is
recommended for most users.
Capacity/ Cylinder/ Head/ Precomp/ Landing Zone/ Sector
These settings designate individual IDE-type Hard Disk parameter settings.
When the [IDE Primary Master (Slave)] setting is set to [Manual], the Access Mode
must be [CHS]. When the [IDE Primary Master (Slave)] setting is set to [Auto], these
values are automaticaly detected.
[Capacity] is set automaticaly.
IDE HDD Auto-Detection [Press Enter]
IDE Primary Slave
[Auto]
Access Mode
[Auto]
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Phoenix First BIOS
(tm)
Desktop CMOS Setup Utility
IDE Primary Master
Item Help
Menu Level
To auto-detec the HDD's size,
head.... on this channel
↑↓→←
:
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
5.2.2 IDE HDD Auto-Detection
