LT General Overview
20
Certifications and Standards
Introduction
Pro-face submitted this product for independent testing and qualification by third
party listing agencies. These agencies have certified this product as meeting the
following standards.
For information on Standards and Regulations, such as certified models and
certificates, see the marking on the product or the following link:
http://www.proface.com/worldwide.html
Agency Certifications for LT Unit
LT is manufactured in accordance with UL 508 and CSA C22.2 n
°
142 for Industrial
Control Equipment.
For use on a flat surface of a Type 1, Type 4X (indoor use only) enclosure.
Hazardous Substances
The LT is a device for use in factory systems. When using the LT in a system, the
system should comply with the following standards in regards to the installation
environment and handling:
z
WEEE, Directive 2002/96/EC
z
RoHS, Directives 2011/65/EU
z
RoHS China, Standard SJ/T 11363-2006
CE Markings
This product conforms to the necessary requirements of the following Directives for
applying the CE label:
z
2006/95/EC Low Voltage Directive
z
2004/108/EC EMC Directive
This conformity is based on compliance with IEC61131-2.
CAUTION
ENVIRONMENTAL HAZARDS TO THE EQUIPMENT
z
Allow the device to reach the surrounding air temperature, not exceeding 50
°
C
(122
°
F), before turning the device on.
z
Do not turn on the device if condensation has occurred inside the device. After
it is completely dry again, the device may be turned on.
z
Do not expose the device to direct sunlight.
z
Do not obstruct the vents in the device casing.
z
Remove any dust from the device before turning it on.
z
Ensure that the cable installation fasteners are not damaged. Replace them, if
necessary.
z
Mount the device into an enclosure that meets the IP65 level of protection.
Failure to follow these instructions can result in injury or equipment damage.
Summary of Contents for LT series
