E4-6
GP2000 Series VM Unit User Manual
COLOR ADJUSTMENT
Use this setting to adjust the red, green and blue colors.
The settings above are stored in GP/GLC unit's backup SRAM. At the same
time, the screen settings brought in via the RGB IN line will be saved based on the
signal type as a VGA, SVGA or VGAS70<640 x 400 dots> image file. When you
change the GP/GLC unit or the VM unit, these settings will need to be set (en-
tered) again.
4.2
VGA/SVGA Display Adjustment
Touching
at the left side of the Menu bar three times calls up the "PC SCREEN
SETTING" screen.
Then, touch any of the detail settings shown below to call up that setting screen.
Touch "DEFAULT SETTING" to return all items to their initial settings.
POSITION ADJUSTMENT
Adjust the horizontal and vertical positions of the RGB IN image.
SCREEN ADJUSTMENT
Touch "CLOCK ADJUSTMENT" and/or "PHASE ADJUSTMENT".
"CLOCK ADJUSTMENT" is an option for adjusting the horizontal length of the
screen to align with the display width of the TFT panel.
The "PHASE ADJUSTMENT" is used to adjust the image when the image is not
properly displayed after the CLOCK ADJUSTMENT setting is used.
• For GP/ABS3000 Series operation details, please refer to “Maintenance/
Troubleshooting”.
Here describes the operation of the RGB IN image settings when using GP/GLC2000
Series. Use the GP/GLC2000 Series unit’s “Menu Bar” to adjust it. To display the
Menu Bar, refer to “GP-2400/2500/2600 Series User Manual”, or “GLC2400/2500/
2600 Series User Manual”.
