E4-2
GP2000 Series VM Unit User Manual
This setting allows you to adjust the video image display quality.
To display the setting screen, select the "INITIALIZE", "SYSTEM ENVIRONMENT
SETUP" and "VIDEO DISPLAY ADJUSTMENT" screens. (This menu is displayed
only when the VM Unit is installed.)
The current video image appears on the left of the screen. You can adjust the screen
while viewing the actual display.
4.1.2
VIDEO DISPLAY ADJUSTMENT
VIDEO DISPLAY ADJUSTMENT (1/4)
When converting GP-530VM unit screens to GP2000 unit data, be aware
that the starting address of the video control area will be different.
CENTER ZOOM OPERATION (only when Video Mode is set to COMPATIBLE")
This setting designates whether to enable or disable the center zoom feature.
When the center zoom feature is enabled, the center of the video image is magnified
when normal mode is switched to zoom mode. When the feature is disabled, the im-
age is magnified by setting the video display origin point (specified in the video
control area) at the center of the GP/GLC unit's screen.
VIDEO INPUT SIGNAL
Select from "NTSC" or "PAL".
VIDEO MODE
Select from "COMPATIBLE" (with GP-570VM), and "EXTEND".
• Here describes the operation when using GP/GLC2000 Series. When using
GP/ABS3000 Series units, to display the setup screen, select the OFFLINE
mode, "Main Unit Settings", "Video Module Setiings", and "Video Display
Adjustment" screens. For details, refer to "Maintenance/Troubleshooting".
INPUT CHANNEL
Select video device's input channel (VIDEO IN 0 through 3).
MODE
Select whether the input from the video device is color or monochrome. Designate this
setting for each input channel used.
