E3-1
GP2000 Series VM Unit User Manual
3.1
Installing the VM Unit
• To prevent an electric shock, prior to the installation be sure to check
that the GP/GLC/ABS and VM Units are not connected to a power
supply.
• Do not touch the circuit board mounted on the inner face of the VM
Unit.
WARNINGS
Chapter 3 : INSTALLATION AND WIRING
1. Unplug GP/GLC/ABS unit's power
cord .
2. Remove the rear face connector
cover attached to GP/GLC2000
Series Expansion Unit I/F 2 (EXT2)
or GP/ABS3000 Series VM Unit I/F.
3. Carefully insert the VM Unit into the
GP/GLC/ABS until the GP/GLC/
ABS and VM Unit connectors are
securely attached.
4. Use a screwdriver to attach each of
the VM Unit's attachment screws.
(Screws are provided with VM
Unit)
Tightening torque: 0.5 to 0.6 N•m
Attachment
Screws
Connector Cover
When installing/removing the VM Unit, be careful not to lose the attach-
ment screws.
Rear Face of GP-2500T
