E1
GP2000 Series VM Unit User Manual
Thank you for purchasing the Pro-face GP2000 VM Unit (GP2000-VM41). The VM
Unit is installed in the rear of the Pro-face GP2000/3000 Series Operator Interface
(hereafter referred to as the "GP") , GLC2000 Series Operator Interface (hereafter
referred to as the “GLC”) and ABS3000 Series Operator Interface (hereafter referred
to as the “ABS”). The VM Unit allows the GP/GLC/ABS to display images taken
with a video camera or sent from a PC.
Please note that you will need the following;
• GP-PRO/PB III for Windows Ver. 5.05 or higher for GP/GLC 2000 Series to
use the entire range of VM Unit features.
• GP-Pro EX Ver.1.10 or higher will be needed for GP3000 Series.
• Pro EX for BA Ver.2.10 or higher will be needed for ABS3000 Series.
This manual provides important information for using the VM Unit with the GP/GLC/
ABS. Be sure to read the relevant sections prior to using this unit, and store it in an
easy-to-find, safe place.
© 2001,2006, 2007 Digital Electronics Corporation.
The company names and product names in this manual are the registered trademarks
of their respective companies.
PREFACE
1)
It is forbidden to copy the contents of this manual, in whole or in part, without
the express permission of Digital Electronics Corporation of Japan.
2)
The information provided in this manual is subject to change without notice.
3)
This manual has been written with care and attention to detail; however, should
you find any errors or omissions, please contact Digital Electronics Corporation
and inform them of your findings.
4)
Please be aware that Digital Electronics Corporation shall not be held liable by
the user for any damages, losses or third party claims arising from any uses of
this product.
5)
This unit is UL/c-UL (CSA) approved and CE marked. However, when this
unit is installed in a GP2000/ABS3000 series unit that does not comply with UL/
c-UL (CSA) and CE standards, the combination will cause the VM Unit to fail
to comply with CE and UL/c-UL (CSA) standards.
NOTE:
