3
INSTALLATION
•
The dryer should be mounted between 1.4m for a child to 1.7m for an adult from
the floor measured to the bottom of the casing.
•
Drill two holes 6mm dia into the wall at 217mm centres vertically (see template
supplied).
•
Fit the wall plugs and attach the upper hanger using the screw provided.
•
Remove the retaining screw and open the dryer bottom access cover below the
shaver socket.
•
Suspend the dryer from the hanger and fix into place by inserting the lower screw
through the bottom mounting hole and screw into the lower wall plug.
•
If you have an existing wiring and do not need the mains wire already fitted to the
dryer, there is an additional rear cable entry point on the rear cover.
•
The wiring terminals are also accessible through the bottom access cover.
•
Switch off the mains supply before connecting the wiring as follows:-
Live - Brown or red
Neutral - Blue or black
•
If you are connecting to a fused spur, a 13A fuse should be used.
•
Restore the power supply once the installation is complete.
WARNING:
It is not recommended to attempt to remove the air pipe as there is a risk of
damaging the appliance.
•
In order to remove the air pipe insert a narrow flat blade screwdriver into the slot in
the connector and depress the tab and then rotate the pipe to the left by 15 degrees
then gently pull the pipe clear.
•
To refit the pipe engage the connector into the receptacle, push fully home and
rotate to the right until the tabs engage.
10
8
