6
Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases
during normal operation. For this reason it is of the utmost importance that prior to each use of your charger, you
read and follow the instructions provided exactly.
Il est dangereux de travailler a proximité d’une batterie au plomb. Les batteries produisent des gaz explosifs en service
normal. Il est aussi important de toujours relire les instructions avant d’utiliser le chargeur et de les suivre à la lettre.
CHARGING INDICATIONS
When your battery charging system is activated, the battery status indicator provides charging information utilizing a
combination of six LED indicators to display the battery type being charged and the percent of charge on the battery pack.
Battery Type Indicators
Two LED indicators are provided in order to display what type of charge profile is being
applied.
NOTE:
For information on reconfiguring the charge profile, please contact
technical support (800.742.2740). Also see special instructions on page 8.
Battery System Percent Charged Indicators
Four LED indicators are provided in order to display the progress of the charge cycle in
percentage of charge.
Indications are as follows:
1
ST
LED . . . . . …. . . . . .
Illuminated configured for Wet Cell and AGM batteries(Using our DeltaVolt Profile)
2
ND
LED ... . . . . . . . . . . . .
Illuminated configured for Wet Cell and AGM batteries(Using the Club Car Processor)
3
RD
LED . . . . . . . . . . . . .
Charging - Initial Charging Up To 30%
3
RD
& 4
TH
LEDS . . . . . . .
Charging - 60% Complete
3
RD
, 4
TH
& 5
TH
LEDS . . . .
Charging - 90% Complete
BLINKING GREEN LED . . . . Finishing Stage
STEADY GREEN LED . . . . . . Charge Complete - Monitoring Batteries
The green LED is illuminated whenever the charge cycle has terminated and the internal circuitry has determined the
batteries to be fully charged. The green LED will blink during the finishing stage of the charge cycle. After the completion of
the charge cycle, the green LED will remain on steady during the float-maintenance stage.
During this final stage current
is only flowing to the battery system for 5 minutes and then current will stop completely for 60 minutes.
Your system provides an equalization stage every 30 days while plugged in. If the charger is normally disconnected
from A/C after completing charge, equalization can be accomplished by plugging back into A/C whenever this stage
is desired. Battery manufacturers recommend that equalization is done once a month in order to further reduce
sulfation on the lead plates of a battery, which helps promote longer battery life. Note: During this process the
LEDs will go through their normal routine(Red LEDs counting up for % of charge along with the illuminated LED
Battery Type) and then the Green LED and Battery Type LED will blink) until the unit returns to the maintenance
mode and a steady Green LED and steady Battery Type LED. (Not applicable to Gel Profile)
TROUBLESHOOTING
PROBLEM: No LED indicators illuminated on battery status indicator.
Solution Sequence:
1. Confirm that current is being delivered to the charger. Use a meter or test light to check the AC power supply from its
source through all connecting points up to the charger.
2. Check that the AC circuit breaker (on front of the unit) is depressed.
3. Call technical support for further assistance (800.742.2740).
PROBLEM: The charge status indicator changes rapidly back and forth from red to green or the green LED will not
illuminate after excessive charging time (24 hours or more).
Solution Sequence:
1. Disconnect AC power from the charging system. This indication may signify a possible battery problem.
2. Call technical support for further assistance (800.742.2740).
