Priva B.V.
12
FS Cradle – Installation manual – 1.2
Installation - positioning the unit
Location and environmental conditions
The FS Cradle has been tested and can operate in greenhouse environmental conditions;
however it should not be placed under direct spray of water, maximum humidity or under direct
influence of abrasive or aggressive chemicals.
Direct sunlight should also be avoided, because it can reduce the battery condition of the FS
Readers during the charging process.
Basic facility requirement
The FS Cradle requires a standard power socket to plug in and become operational. The FS Cradle
will be delivered with a power cord designed for the region in which the equipment can be used
and therefore no further equipment is needed to use the FS Cradle.
Positioning the unit
The FS Cradle should be positioned in a central place where employees start or gather in the
morning or end the working day and should be positioned so that it is clearly visible to
employees coming in for work.
The cradle can stand on itself, on a flat horizontal surface or can be mounted on a flat vertical
surface (i.e. a wall).
For positioning the FS Cradle on a flat horizontal surface, the 4 “rubber base sticky feet” that are
included in the package should be glued to the four corners on the bottom of the unit, at 1 cm
from the surrounds.
For mounting the FS Cradle to a wall:
•
Select a wall that is amply strong enough to hold the weight of the FS Cradle and that can
withstand the repeated pressure of putting FS Readers into the charging positions of the FS
Cradle.
•
Use a proper drilling machine to drill two holes (8 mm wide, 45 mm deep) at the correct
horizontal distance (check the rear side of the FS Cradle).
•
Put the plugs that are provided with the FS Cradle into the holes and drive the provided
screws into the plugs.
•
Place the FS Cradle over the screws.
