A Picture to
Remember
INSTALLATION INSTRUCTIONS
Carefully
remove and unwrap all the
contents of box. Referring to the parts
list, make sure you have everything
needed to proceed with the installation
of the lens. If any parts are missing,
contact Prismasonic immediately.
Inspect the lens to make sure there are
no shipping defects. If you notice a
problem with the lens itself, or the lens’
mechanical system, contact Prismasonic
immediately.
Parts list:
Lens Unit
Table Stand
Power Cord
Power Converter
Remote Controller
L-Wrench, 3 mm
L-Wrench, 4 mm
Instruction Manual
Bringing the lens into the use:
STEP 1
Lift the lens up and flip it upside down
in a
stand.
By using the
L-wrench, 3 mm
remove
the delivery lock screws of prisms from
bottom
plate
(
Fig 1-a).
After this carefully remove the
front element
by releasing the four cap screws
(Fig 1-b)
. Put the front element in a safe place
waiting for the further use. After this remove the
bottom plate
of housing by releasing the four
screws on the bottom plate
(Fig 1-c)
.
STEP 2
Now carefully take off the plastic cover sheets
from both sides of both lenses
(Fig 2).
Remove
also the cover coats from both IR windows of
motor box.
Fig 1
b)
b)
c)
b)
b)
c)
c)
c)
a)
a)
Fig 2
Fig 3
STEP 3
Insert the bottom plate back to the housing and
prepare to affix the four screws
(Fig 3
) with
L-
wrench, 3mm.
Tighten the screws securely.
At this point, do not yet insert the
front
element
back to its place, since it has to be
unassembled while setting up the system.
Flip the lens back upright in a stand.
Your lens is
now ready for the setting up!
Anamorphic Lens
H-FE850R
Setup Instructions
Anamorphic Lens
H-FE850R
