Prinzen PSPC5, Service Manual, Page: 63 / 73

30 CELL TRAY DENESTER
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 63 of 73
DENESTER STOP POSITION
The stop position of the tray denester is factory
set. When the tray denester stops, the lower
grippers are at the lowest position and the
crank position is completely vertical.
After a replacement of parts of the drive
mechanism, adjustment of this stop position
may be needed.
Follow below procedure for stop position
adjustment:
40. Press the emergency button and remove
the cover around the clutch.
41. Lift the circlip with a screwdriver and move
it as far as possible towards the
gearwheel.
42. Move the cam ring as far as possible
towards the gearwheel until it is able to
rotate.
43. Rotate the cam ring and place it back.
ATTENTION!
Do not remove the bottom ring. This ring is
factory set. Removing this ring damages the
clutch.
TIP!
A small movement of the cam ring results in a
big change in the stop position.
44. Pull the emergency button and start the
system by pressing the start button twice.
45. As soon as the outfeed conveyor is
running, set the selector switch to INCH.
The denester makes one complete stroke
and stops in the bottom position.
46. Check the lowest position. At this position
the tie rod and the crank should be
vertical.
47. Repeat 40 to 46 until the tie rod and crank
are in the vertical position.
48. Place back the circlip to lock the cam ring
on the clutch. Place back the cover
TIE ROD ADJUSTMENT
The tie rods (46) are factory set. We advise
you to consult Prinzen before adjusting this tie
rod!
1
41
41
42
7
45
44
40
46