Prinzen PSPC5, Service Manual, Page: 62 / 73

30 CELL TRAY DENESTER
Page 62 of 73 SERVICE MANUAL PSPC5 SM-PSPC5-01-E/12-2007
ADJUSTMENTS 30 CELL TRAY
DENESTER
BUNKER ADJUSTMENT
Make sure there is a free space for the stack of
trays (20) inside the bunker. Adjust this space
with the positions of the sides (21) of the
bunker. Adjust the 4 sides in such a way that
the trays are centred on the output conveyor.
TRAY GUIDE
Both tray guides (22) should be as far as
possible towards the transport belt (23) of the
output conveyor without touching this belt.
LOWER GRIPPERS
Adjust the position of the lower grippers when
the denester block is in the top position (24).
Stop the system by pressing the stop button
(25). “Machine stopped by stop button” is
visible on the display. Activate the INCH button
(26) shortly to move the denester block to its
top position.
When the pins of all grippers (27) are inside
the tray, there must be a space of 1 mm
between the bearing of the denester block and
the slot in the frame (28).
Adjust by changing the position of the lower
grippers (29). Make sure that on all 4 positions
the bearings do not touch the frame.
TOP GRIPPERS
Adjust the position of the top gripper when the
denester is beyond the top position and the top
grippers are completely at their bottom position
(30).
The position of the top grippers should be just
above the lowest tray (31).
It is possible to adjust this gripper in all 3
directions (32). Make sure all 4 grippers are
adjusted correctly.
20
21
21
23
22
29
28
27
24
26
25
30
31
32
32