Prinzen PSPC5, Service Manual, Page: 47 / 73

PACKER
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 47 of 73
VACUUM HEAD HORIZONTAL
POSITION
The position of the vacuum head must be
horizontal in all positions (60). To adjust this,
loosen up the 2 bolts (61) that hold the
sprocket and reposition the sprocket. Tighten
up the bolts afterwards.
VACUUM LIFTER CHAIN
TENSION
The chain tension of the vacuum lifter is
adjustable by changing the position of the
chain tensioner (62).
VACUUM HEAD FRONT REAR
The suction cups of the vacuum head must fit
into the cups. Make sure that the center
suction cups (63) are exactly in the center of
the cups (64).
Adjust the front rear position of the vacuum
head by loosening up the 2 bolts (65) that
connect the complete vacuum head holder on
the beam. Move the complete vacuum head
holder to the correct position and tighten up the
2 bolts again.
TIP!
Make sure the cup conveyor is at the correct
stop position before adjusting the vacuum head
position.
VACUUM HEAD LEFT RIGHT
The suction cups (66) of the vacuum head
must fit into the cups (67).
Adjust the left right position of the vacuum
head by loosening up the 4 bolts (68) that
connect the vacuum heat to the vacuum head
holder. Move the vacuum head to the correct
position and tighten up the 4 bolts again.
62
Front Rear
Left Right
63
64
65
65
68
68
68
68
66
67
60 61