Printware iJet Press, Operator'S Manual, Page: 33 / 88

SECTION 3
OPERATING THE PRINTER
27
Printer Status Light Indicator Chart (see legend)
Valid with Firmware 110928_u or higher installed.
ON/OFF
PAPER
RESUME
PAUSE
CANCEL
Printer Status
corresponding Toolbox message
Additional Details, Possible Solution or Action

OFF

OFF

OFF
Print engine is powered-OFF
In this condition, it is safe to turn the Main Power Switch OFF or ON.
IMPORTANT : To provide proper printhead and ink system
maintenance; the printer should remain powered on (ON/OFF light
illuminated) at all times.

ON

OFF

OFF
Print engine is powered-ON and ready
Printer is Ready

/
 
/
 
/

Print engine powering-up
It takes approximately 45 seconds for the print engine to power-up;
after pressing this button.
All lights blink simultaneously during power-up sequence.
The ON/OFF button will change to a steady illumination condition,
once the print engine is fully powered-up.
TIP : You can launch (open) the Toolbox after the lights come on.
Print engine powering-down
All lights blink simultaneously during power-down sequence.
Wait until all lights go out before turning OFF the Main Power
Switch.

ON

/
 
/

Busy: Job Loading Wait for lights to stop blinking.
Printer is Performing Maintenance
(Cleaning, Circulating Ink, etc..)
Toolbox =
MAINTENANCE_BUSY
Wait for lights to stop blinking.
Canceling Job. CANCEL key was pressed
Toolbox =
MECH_CANCELJOB
Wait for lights to stop blinking.

ON

/
 
/

Printer is Printing
Press PAUSE, to pause printing.
TIP:
If the printer doesn’t try to feed media; check for paper jam in
print engine and clean the PaperPath sensors.
Please see the “
Toolbox System Status Messages
” section for more details on Toolbox messages.
Simultaneous Flash (1/sec)
Simultaneous Flash (1/sec)
Alternating Flash (1/sec)