13
6. Coarse Mechanical Alignment
1. Loosen the two captured screws securing the side plastic cover located on the inboard side of the ODV, then
squeeze the top and bottom of the cover to release its 3 locking tabs and remove the cover to access the locking
and adjustment screws. Set the cover aside.
Figure 15:
Removing the Plastic Cover on the ODV2D-V2
2. Place a 6 inch square between the ODV2D-V2 and the mounting bracket to verify that the back of the ODV is at
an exact 90 degree angle with the ODV mounting bracket. There should be no gaps on either edge of the square.
Proceed to Step 3 if adjustment is needed.
Figure 16:
Verifying a 90 Degree Angle Exists Between the ODV and Bracket
Locking Tabs (3)
