Prins Direct LiquiMax, Installation Manual

Page: 38 / 38

PAGE 37 076/0705500
Copyright © Prins Autogassystemen B.V. 2014
Checklist after installation
1.
Install the system fuses.
Turn on ignition.
Connect the Prins interface wire and run the Prins diagnosis program.
When working on the car, beware of moving and rotating parts in the engine compartment
( even when the engine is not running !! ).
2.
When commissioning the LPG system, you must activate the AFC with the diagnosis software.
3.
Check whether the program in the AFC matches with the car ( dedicated engine set ):
See “Identification” in the diagnosis program.
4.
Check all components and connections for any LPG leakage, use a LPG leak detector device or
a fluid detection like soap. Also check for petrol leakage. Make sure the solenoid valves are in open position.
No evidence of leakage is permitted.
Caution for moving and rotating parts in the engine compartment !
5.
Use the diagnosis software to check again all input and output signals.
6.
Check the system for error codes and solve these, if required.
Check the petrol MMS for EOBD error codes.
Place the protection connector back on the diagnose connector.
7. Make a test drive and check the cars drivability on LPG and petrol.