Panther T14R - Operation and maintenance manual
COMPONENTS OUTSIDE THE CAB
74/178
The cameras are equipped with infrared LED night
vision system and heating elements to provide low
temperature operation.
ROOF GRILL (FOPS)
Figure 130
Roof FOPS structure
A grill adapted to the curve of the roof may be installed
over the cab to conform with the FOPS (Falling
Objects Protective Structure) standard. It is designed
for areas where falling objects pose hazards to the
occupant in the cab.
Never install a grill and attaching hardware other than
the genuine PRINOTH parts. Refer to the label in the
cab for information on the FOPS.
WARNING
Crush hazard
Altering the roof grill structure (FOPS) could
reduce its resistance to falling objects and
cause severe injuries or death. Do not modify
the grill and its attaching hardware in any way.
0274670156
BRUSH GUARD
Figure 131
1. Brush guard lower section
2. Brush guard upper section
3. Upper fastener
4. Lower fastener
The front brush guard is divided in two removable sec-
tions (to provide better visibility if protection is tempo-
rarily not required). The sections are identical except
for some of the fasteners. The top section can be
stowed (“snapped”) in front of the bottom section.
To remove the top section, pull it forward to disconnect
the top fasteners (item 3 on previous figure). Then,
pull the unit up to disconnect the lower fasteners
(item 4). Store the section in a suitable location or relo-
cate it in front of the bottom section.
0274670017
1
3
2
4