Panther T14R - Operation and maintenance manual
LATERAL CONSOLE
38/178
PRE-HEATER CONTROL UNIT
Figure 44
Engine pre-heater control unit
This unit controls the engine coolant heater system
that may be used to help start the engine in cold
weather. The system uses the same fuel and fuel tank
as the diesel engine and does not required outside
electrical power to operate.
Use the pre-heater system only when the vehicle is
outside (or well ventilated area) and not being refu-
WARNING
Explosion hazard
Fumes from refuelling could ignite and cause
severe injuries or burns.
Always switch off the heater BEFORE refuelling
the vehicle.
Do not operate the heater in an area where toxic
or explosive materials or fumes may be present.
WARNING
Asphyxiation hazard
Breathing exhaust gases from the heater could
cause severe injuries or even death. Always use
the heater when the vehicle is outside or in a
well ventilated area.
NOTICE
Damage by freezing
Damage could occur if the heater is operated
while the coolant is frozen in the hoses. Ensure
the coolant is compatible with the heater speci-
fications.
0275580014
elled. Operation is unrestricted below 1500 m (5000 ft)
of altitude. Consult a PRINOTH representative for
operation above 1500 m (5000 ft).
It is not recommended to operate the pre-heater when
the diesel engine is running.
Refer to the heater supplier literature for safety precau-
tions and other tips on operation/maintenance of the unit.
Preselected starting times
The preselected starting time is the time at which the
timer switches the heater on automatically. The
Webasto SmarTemp Control fx allows for preset start-
up cycles of your Webasto heater up to 7 days in
advance with 4 unique programs for each day.
Operating time
The period of time during which the heater is in opera-
tion is referred to as operating time. The heater
remains in operation for as long as the operating time
has been preset. Heater operation can be preselected
for any time from as little as 10 minutes to a maximum
of 120 minutes (factory preset is 60 minutes).
Remaining Operating Time
The remaining operating time refers to the period of
time the heater still continues to remain in operation.
This can be changed with duration menu feature.
Setting the SmarTemp Control fx
The Webasto SmarTemp Control fx can be operated
using a single rotary dial around the outside of the unit
to browse through different menu options. Simply click
the selection button (
) to make your choice. The
following sections will define each menu item and its
default setting.
Once the power has been connected, the time and
date must be set. This can be done by using the rotary
knob and the selection button as mentioned above.
Within the timer menu, select the day or the specific
timer program (T1 - T4) using the rotary knob. Once
the day, time, and duration have been entered within
the calendar table, press the selection button to set. A
checkmark will confirm the program has been saved.
Each program can be edited or removed simply by
selecting the box again.