LIMITED WARRANTY
Primo Water Corporation, (“Vendor”) warrants to the original purchaser of this
dispenser, and to no other person, that if this dispenser is assembled and operated in
accordance with the printed instructions accompanying it, then for a period of one (1)
year from the date of purchase, all parts in such dispenser shall be free from defects
in material and workmanship. Vendor may require reasonable proof of your date of
purchase from an authorized retailer or distributor. Therefore, you should retain your
sales slip or invoice. The Limited Warranty shall be limited to repair or replacement
of parts, which prove defective under normal use and service and which Vendor shall
determine in its reasonable discretion upon examination to be defective. Before
returning any parts, you should contact Vendor’s Customer Service Department using
the contact information listed below. If Vendor confirms, after examination, a defect
covered by this Limited Warranty in any returned part, and if Vendor approves claim,
Vendor will replace such defective part without charge. If you return defective parts,
transportation charges must be prepaid by you. Vendor will return replacement parts
to original purchaser, freight or postage prepaid.
The Limited Warranty does not cover any failures or operating difficulties due to
accident, abuse, misuse, alteration, misapplication, improper installation or improper
maintenance or service by you or any third party, or failure to perform normal and
routine maintenance on the dispenser, as set out in the User’s Manual. In addition,
the Limited Warranty does not cover damages to the finish, such as scratches, dents,
discoloration or rust after purchase.
The Limited Warranty is in lieu of all other express warranties. Vendor disclaims all
warranties for products that are purchased from seller other than authorized
retailers or distributors. AFTER THE PERIOD OF THE ONE (1) YEAR EXPRESS
WARRANTY, VENDOR DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING
WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. FURTHER, VENDOR SHALL HAVE NO
LIABILITY WHATSOEVER TO PURCHASER OR ANY THIRD PARTY FOR ANY SPECIAL,
INDIRECT, PUNITIVE, INCIDENTAL, OR CONSEQUENTIAL DAMAGES. Vendor assumes
no responsibility for any defects caused by third parties. This Limited Warranty gives
the purchaser specific legal rights; a purchaser may have other rights depending
upon where he or she lives. Some jurisdictions do not allow exclusion or limitation of
special, incidental or consequential damages, or limitations on how long a warranty
lasts, so the above exclusion and limitations may not apply to you.
WINSTON-SALEM, NC 27101
866-429-7566
WWW.PRIMOWATER.COM
BOTTLED W
ATER
DISPENSER
Quick Start Guide
#601234
© 2016 Primo Water Corporation
QUICK START GUIDE
1
Place the dispenser on the
floor in the desired location
in your home. If the surface is
uneven, rotate the back feet
to level out the dispenser.
3
Clean probe with a damp
cloth and dish soap. (Visit
www.primowater.com for
detailed cleaning instructions.)
Place probe assembly on
hanger inside door to keep
it clean.
2
Slide drip tray into place.
4
Grab a bottle of Primo
®
water and fully remove the cap.
Insert probe assembly into
bottle. Press firmly to secure
assembly over bottle opening.
For 3 and 4-gallon bottles,
squeeze the tabs on the top of
the probe assembly to separate
the probe cap from the collar and
press the collar securely over the
bottle opening.
5
Slide bottle inside the
cabinet and close cabinet door.
6
Plug dispenser into
a ground fault circuit
interrupting (GFCI) outlet.
You will hear the dispenser
begin to pump water to
fill the internal hot and
cold tanks.
7
Turn on desired functions
by flipping the switches on the
back of the dispenser to the
ON position.
Blue – nightlight
Green – chills water
Red – heats water
Black – activates self-sanitization
(press and hold for 5 seconds)
8
Once the dispenser has
stopped filling the internal
tanks, dispense and dispose at
least 1 quart (approximately
2 pint glasses) of water.
9
Your water will be ready
to dispense fully chilled in
approximately 1 hour or
piping hot in approximately
12 minutes.
10
Register your dispenser
at
www.primowater.com
to
activate your warranty.
Inside of door
1
QT
1
HR
12
MIN
®
®
®
5
Gallon
3
Gallon
ON
OFF
ON
OFF
ON
OFF