Primes MicroSpotMonitor Plus HighBrilliance, Original Instructions Manual

Page: 51 / 116

51 Revision 00 EN - 02/2022
MSM+ HB
35,0(6
9.4 General procedure for measuring
This chapter contains general information about the LaserDiagnosticsSoftware LDS. Read this general infor-
mation before turning to the following chapters on the different measuring tasks.
9.4.1 Open the „Device control“ menu
After connecting the device, the
Device control
menu must be opened:
1. Click on the Devices tab.
2. Select the device and click on the de-
vice function CCD below the device
name.
The Device control menu with the
Adjustment and Measuring modes
sections opens.
Device function
9.4.2 Move camera housing to desired z-position
The Adjustment area of the Device control menu offers various options for moving the camera housing.
Option Explanation
z-Position in mm X Enter the desired z-position in the input field or use the slider.
Move to axis position X
Click this button to move the camera housing to the z position spe-
cified in the
z-Position in mm
field.
Move to axis center position X Click this button to move the camera housing to the center position
of the (unlocked) z-axis traversing range.
Note that this does not have to be the maximum traversing range of
your device. If a locked area of the z-axis was stored in the EEPROM
during a previous use of the device, then this locked area is active. The
camera housing then moves to the center position of the unblocked
area.
Tab. 9.2: Options in the Adjustment area of the Device control menu