Primes MicroSpotMonitor Plus HighBrilliance, Original Instructions Manual

Page: 41 / 116

41 Revision 00 EN - 02/2022
MSM+ HB
35,0(6
Connecting cooling circuit at MSM+ HB20
There is no adapter required for the
MSM+ HB20.
X
Connect the cooling water directly to the device.
Water in
Water out
8.9.2 Danger to the device
NOTICE
Damage/Destruction of the device
If the following requirements for the cooling circuit are not observed, the measuring device
may be damaged.
X
Observe the following requirements.
Water quality
The device can be operated with tap water as well as demineralized water.
An operation with strongly deionized water (DI-water, conductivity < 30 µS/cm) is only possible with the res-
pective connection parts (stainless steel) – we would be glad to advise you if necessary.
Large dirt particles or teflon tape may block internal cooling circuits. Therefore, please thoroughly rinse the
system before connecting it.
Aluminum components
Do not operate the device on a cooling circuit in which aluminum components are installed. Otherwise, cor-
rosion in the cooling circuit can occur, particularly when operating at high powers and power densities. In the
long term, this will reduce the efficiency of the cooling circuit.
8.9.3 Parameters of cooling water connection
Data MSM+ HB10 MSM+ HB20
PE hose diameter 12 mm 16 mm
Recommended flow rate 7 - 8 l/min 14 - 16 l/min
Minimum flow rate 5 l/min 10 l/min
Recommended water pressure 2 bar 2 bar
Maximum water pressure 4 bar 4 bar