Primes MicroSpotMonitor Plus HighBrilliance, Original Instructions Manual

Page: 12 / 116

12
Revision 00 EN - 02/2022
MSM+ HB
35,0(6
Do not lift the device by the objective
Labeling according to WEEE directive:
The device must not be disposed of with household waste, but in a separate WEEE collection
in an environmentally friendly way.
Further symbols and conventions in this operating manual
Here you can find useful information and helpful tips.
X
Indicates a simple instruction.
If several such instructions appear one below the other, then the order of their execution is irrele-
vant or they are alternative procedures.
1.
2.
... A numbered list identifies a sequence of instructions that must be executed in the specified order.

Indicates the result of an action to explain processes that take place in the background.
Indicates an observation prompt to draw attention to visible feedback from the device or the soft-
ware.
Observation prompts make it easier to check whether an instruction was executed successfully.
Often they also guide to the next instruction.
Points to a control element that is to be pressed / clicked.
Points to an element described in the text (for example an input field).
3 About this operating manual
This manual describes the installation and operation of the MSM+ HB and how to perform measurements
with the LaserDiagnosticsSoftware LDS 1.1.2.
For measurement operation with a PC, the LaserDiagnosticsSoftware LDS must be installed on the PC. The
LDS is included in the scope of delivery.
The software description includes a brief introduction on using the device for measurements.
For a detailed description of the software installation, file management and evaluation of the measurement
data, please refer to the separate instructions for the LaserDiagnosticsSoftware LDS.
This operating manual describes the software version valid at the time of printing. Since the operat-
ing software is subject to continuous further development, it is possible that the the supplied data
carrier may contain a higher version.
If you have any questions, please let us know the software version you are using. The software version can
be found under the following menu item:
Help > About LaserDiagnosticsSoftware .