35,0(6
Cube L1
41
Revision 03 EN - 03/2021
14.5
Start measurement
Measurements with the Cube L1 should be performed exclusively with a static (motion-
less) laser beam.
The measurement is started automa-
tically when the laser is switched on.
The display field
Start
is therefore not
active.
A measuring cycle (measure, ther-
malize, send data) takes approx.
15 seconds. The device is then ready
for a new measurement.
If you have previously displayed a
measurement in the toolbench, press
the
New measurement
button.
If the setting
Autom. ready for
measurement
on page 39) is deactivated, briefly
press the on/off button on the device.
1. Observe the safety instructions
2. Turn on the laser.
The progress of the mea-
surement is indicated in the
Measurement is running
and
then
Measurement is finished
displays.
3. Turn off the laser.
